What happened to Category 7?

With the adoption by the international standardization organizations ISO/IEC and ANSI/TIA of the Category 8 standard for structured cabling systems, you would ask "What are Category 7 and Category 7A used for"?

First, let's clarify that Category 7A is not approved by the American ANSI/TIA. When we talk about Category 7A, we mean the structured caling system Class FA, which was ratified by ISO/IEC only.

Category 7 – Class F was introduced in 2002 to offer a higher frequency (600MHz) and better performance than Category 6, with the idea that such systems could be used to carry 10Gb/s. Later it was realized that 500MHz was sufficient for 10Gb/s and in 2008 category 6A (Cat.6A) standard was adopted and this made category 7 redundant. Cat.7 S/FTP cables are still available, but their use is uneconomical.

A similar case is with Category 7A (Class FA). This standard was adopted by ISO/IEC in 2010 and guarantees a frequency of 1000MHz, which was expected to be sufficient for future 40Gbs applications over copper cable. However, it turned out that for speeds of 25Gbs and 40Gbs a frequency of 2000MHz was required. Therefore, ISO/IEC and ANSI/TIA simultaneously adopted the Category 8 standard specified for frequencies up to 2000MHz. However, Category 7A found its market - the cables proved to be suitable for CATV and AV applications, and even some AV equipment manufacturers require Cat.7A cable to be used in their systems.

Additionally, category 7, 7A use non RJ45 connectors and special adapters shoud be used to test and verify the installed system.

In conclusion, if you are planning speeds greater than 10Gbs the use of structured cabling systems Class F, Class FA and components category 7, 7A is not justified. Wait for the mass introduction of components Cat.8.

Plamen Hubanov

en_GB